Manufacturing Controls Engineer, Machining Lines

What a Tuesday looks like in this job.

7:00 am. A machining line went down overnight. You're on the floor with the technicians, in TIA Portal, chasing a Profisafe fault. You find it, fix it, and write up what happened so it doesn't repeat.

9:30 am. A supplier is on-site commissioning new equipment. You check their work against the plant's electrical and automation standards and push back on documentation that isn't complete.

1:00 pm. Capital project review with plant management. You own the budget and the schedule, and you give them a straight update.

3:00 pm. A newer engineer is stuck on a FANUC robot and Cognex vision setup. You sit with them and work through it.

If that sounds like a good day, a large global manufacturer's machining and assembly plant in Northeast Mississippi is hiring a Manufacturing Controls Engineer.

You'll need a Bachelor's degree in Engineering, 7+ years in automation (manufacturing preferred), deep Siemens PLC and TIA Portal experience, Profibus, Profisafe, Safety Integrated and ASI-Bus, and the ability to create and read electrical, pneumatic and hydraulic schematics. FANUC, Cognex and Atlas Copco experience is strongly preferred. Knowledge of electrical codes and AutoCAD helps.

n return: a fully funded pension on top of a 401(k) with a dollar-for-dollar match up to 5%, medical, dental and vision, tuition reimbursement, company-paid disability and life insurance, 12 paid holidays plus vacation and sick time, and relocation assistance from the Corinth area. Base salary is competitive and shared on our first call.

Work authorization: US citizens and permanent residents preferred; TN and H-1B sponsorship considered for qualified candidates.

On-site in Northeast Mississippi.

Apply with your resume or message me. Confidential.