CNC Machinist Programmer / Operator in FORT MYERS, FL

CNC MACHINIST - MILL PROGRAMMER/SET UP/OPERATOR

7AM-4PM Monday - Friday

MUST BE EXPERIENCED WITH KURAKI, OKUMA AND FANUC programming, set-up, and operation.

WE HAVE OLD AND NEW MASTERCAM VERSIONS ALSO IF NEEDED.

Programming, set up and operation position in Fort Myers, FL.

Youngquist Brothers LLC is a vertically integrated well drilling contractor. This position is for the machine shop in Fort Myers, FL.

Qualifications: Programming and operating CNC mills.

Job Duties:
Under minimal supervision, build complex one or two piece production runs of large machined parts using a CNC mill . Several of the parts machined will require the use of an overhead crane to load the machine.

Applicant must be able to measure a part and produce a copy without support from others.

Experience:
Requires a minimum of 3 years CNC programing and MILLING experience. Must demonstrate ability to program, set up and operate mills.

Special Skills:

• Ability to read and understand engineering drawings.
• Ability to measure and inspect parts.
• Ability to account for tolerances in multiple piece assemblies.

Education:
High school, trade school or equivalent of education and experience. Completion of CNC Programming Trade School or equivalent preferred, but may be substituted by additional, relevant experience.

Equipment:
Okuma Genos M560V with OSP-P300MA control
Kuraki KV-2000 CNC vertical machining center mill with a Fanuc series 16-M controller