Saw Operator

Warehouse Material Handler Moves, stocks, saws, cuts, and stages material within the warehouse. Responsibilities & Duties: Sets up and operates cut-off machines to cut, slot, groove, miter, and trim steel according to specification. Selects and installs blade on machine, using hand tools. Sets controls to adjust speed, feed rate, and blade tensions. Positions guides, stops, holding blocks, or other fixtures to secure and direct steel, using hand tools and measuring devices. Mounts steel in holding device, manually or using overhead crane. Reads job order and blueprint for specifications. Inspects material for quality standards by measuring cut stock with ruler, caliper, or square to verify dimensions against specifications. Operates material handling equipment and stages vehicles to assist in the movement of materials to and from the Saw Department. Performs daily preventative maintenance inspections as required. Follows safety regulations and company work rules for a safe working environment. Maintains a clean working area both during and after the scheduled shift. This list of duties and responsibilities is not all inclusive and may be expanded to include other duties and responsibilities as management may deem necessary from time to time. Requirements: Education and/or Experience: High School Diploma or equivalent preferred, one to three years' relevant experience, or equivalent combination of both preferred. Essential Functions: To perform this job successfully, an individual must be able to perform each essential duty satisfactorily. The requirements listed below are representative of the knowledge, skill, and/or ability required. Reasonable accommodation may be made to enable individuals with disabilities to perform the essential functions. Ability to read and comprehend simple instructions, short correspondence, and memos. Ability to effectively present information in one-on-one and situations to other employees of the organization. Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals. Ability to critically think and solve problems. Ability to deal with problems involving several concrete variables in standardized situations. Requires the ability to operate various tools and equipment to include a computer, side loader, overhead crane, metal cutting saw and various small hand tools. Requires the ability to pass forklift course and drive equipment. Physical Demands: The physical demands described here are representative of those that must be met by an employee to successfully perform the essential functions of this job. Reasonable accommodation may be made to enable individuals with disabilities to perform the essential functions. The phrases "occasionally," "regularly," and "frequently" correspond to the following definitions: "Occasionally" means up to 1/3 of working time, "regularly" means between 1/3 and 2/3 of working time, and "frequently" means 2/3 and more working time). Frequently lift or move up to 25 pounds. Occasionally life or move up to 70 pounds. Repetitive fine motor movements of the fingers, hands, and wrists performing tasks. Frequently working on foot, using tools, and performing repetitive actions that entail bending and stooping. Occasional sedentary work, sitting for extended periods of time. Work Environment: The work environment characteristics described here are representative of those an employee encounters while performing the essential functions of this job. Reasonable accommodation may be made to enable individuals with disabilities to perform the essential functions. The employee works in a factory environment and is occasionally exposed to wet, humid conditions and toxic or caustic chemicals. He/she is frequently exposed to fumes or airborne particles and works near moving mechanical parts. The noise level in the work environment is loud.