CMM Programmer

Responsible for performing advanced First Article Inspections, developing and implementing complex inspection methods, and supporting CMM programming activities. This position demonstrates strong technical expertise in precision measurement, GD&T interpretation, and inspection reporting while operating independently on a wide range of products and manufacturing processes.ESSENTIAL DUTIES AND RESPONSIBILITIESThe duties and responsibilities described are not a comprehensive list and additional tasks may be assigned. To perform this job successfully, an individual must be able to perform each essential duty satisfactorily.Advanced Inspection & MeasurementPerform complex inspections using precision hand tools and measurement equipment with high accuracy and repeatabilitySelect appropriate inspection methods based on part geometry, tolerances, and customer requirementsInterpret engineering drawings, specifications, and GD&T requirements to ensure complianceCMM Programming & Inspection SupportProgram, operate, and troubleshoot CMM systems (Hexagon/Manual/DCC) for standard and moderately complex inspectionsDevelop and modify PC-DMIS inspection routines to support production and First Article requirementsAssist in probe setup, fixture alignment, and measurement validation activitiesSupport troubleshooting of CMM rejections and dimensional discrepancies through 1st-level problem solvingInspection Reporting & DocumentationCreate and format inspection reports and First Article Inspection (FAI) documentationReview inspection data for completeness, accuracy, and traceabilitySupport standardization and consistency of reporting formats and inspection methodsMetrology & Equipment SupportVerify inspection equipment is calibrated and suitable for use prior to inspection activitiesUtilize additional inspection technologies including optical comparators, Keyence systems, and scanning equipment as requiredSupport measurement system validation and equipment maintenance activitiesProblem Solving & Process ImprovementInvestigate dimensional and feature-related nonconformances and support root cause analysis effortsCollaborate with Engineering, Manufacturing, and Quality teams to resolve inspection issuesIdentify opportunities to improve inspection efficiency, repeatability, and workflow consistencyTechnical Support & Knowledge SharingProvide technical support and guidance to Inspectors Levels 1–2Share best practices related to inspection methods, programming techniques, and measurement strategyAssist in onboarding and skill development of junior inspectorsQUALIFICATIONS, EXPERIENCE AND EDUCATION REQUIREMENTSHigh School Diploma or EquivalentMinimum 4+ years of inspection/metrology experienceCompleted GD&T training course & demonstrates ability to apply all conceptsExperience with PC-DMIS, Keyence, optical comparator, and 3D scanning systemsPHYSICAL DEMANDS – GENERAL ACTIVITIESRegularlyFrequentlyOccastionallySittingXStandingXWalkingXClimbing/BalancingXReaching - With Arms and HandsXStooping/Kneeling/Crouching/CrawlingXHearingXFeeling/TouchingXNear/Far Visual AcuityXPHYSICAL DEMANDS – LIFTING REQUIREMENTSRegularlyFrequentlyOccastionallyLifting/Moving up to 10 lbsXLifting/Moving up to 25 lbsXLifting/Moving up to 50 lbsXThis position requires use of information which is subject to the International Traffic in Arms Regulations (ITAR). All applicants must be U.S. persons within the meaning of ITAR. ITAR defines a U.S. person as a U.S. Citizen, U.S. Permanent Resident (i.e. 'Green Card Holder'), Political Asylee, or Refugee.“B&B Manufacturing Co. is an Equal Opportunity/Affirmative Action employer and all qualified applicants will receive consideration without regard to race, color, religion, sex, sexual orientation, gender identity, national origin, protected veteran or disability status, or any other characteristic protected by law.” #J-18808-Ljbffr B