Coating Console Operator

Job Description

Job Description

Job Summary:

• The purpose of the Coating Console Operator is to be responsible for complete control of the oven. Start and stop all motors, fans, exhaust, tenter, pre-tenter, and other equipment pertaining to the operation of the coater.

Essential Duties & Responsibilities:

• Must be able to adjust speeds and synchronize the speeds of the applicator, pre-tenter, and tenter for proper tensions and speeds.
• Observe the level of latex in the application area. Control levels for proper application.
• Make necessary adjustments of rolls and doctor bars on the applicator to apply latex properly. Make necessary adjustments for style changes.
• Assume responsibility for having the proper amount of latex applied to give a quality product.
• Co-directs and instructs coater personnel in changes necessary for correct operation of equipment.
• Assist in cleaning of applicator rolls and pans each day and also weekend cleaning.
• Work closely with the coater supervisor for proper application and performance of the coater range.
• Note type application each day.
• Get the cup weight of latex, record it, and make adjustments.
• Advise the supervisor of improper performance of the equipment.
• Observe the pinning of the carpet at the pre-tenter and make necessary adjustments.
• Keep work area clean.
• Knowledge of the Mahlo Bow Straightener. Align patterns properly
• Climb ladders/stairs. Stooping/crawling to clean bottom press rollers and change out tenter brushes. If pins have buildup, you may need to crouch for up to 30 minutes while cleaning them off. Reaching to open top oven doors when coater stops.

Performance Expectations (if applicable):

• Lifting is required on cups, and buckets weighing approximately 25 lbs. 30 times per shift.
• Standing is required but varies per shift, 4 to 12 hours.
• Reaching is required for cups, buckets, and tools approximately 40 times per shift.
• Stooping is required for cups, buckets, and tools approximately 40 times per shift.
• Bending is required for cups, buckets, and tools approximately 40 times per shift.
• Must be able to use wrenches.

Experience/Education Requirements:

• Computer knowledge or data entry skills are a necessary part of the job.
• High school diploma or equivalent preferred.
• Must be able to read and write and do basic addition, subtraction, division, and multiplication.
• Computer knowledge or data entry skills are a necessary part of the job.

Other Requirements:

• Overtime is required on occasion.
• All accidents must be reported immediately.
• Perform any other duties as assigned.
• Safety equipment must be worn as required, and requirements must be followed for all areas.
• Report to management any quality, safety, or potential problems encountered while performing the job.
• Responsible for the quality and safety of his/her own output.