Station Servicer C - Station Servicer

Station Servicer

Participate in the construction, maintenance, rebuild, removal, operation, testing and inspection of energized or de-energized generation, transmission and distribution facilities. Work with existing Station Servicer in assigned area to inspect and maintain assigned station facilities with expectation to progress to Station Servicer in the assigned area. Assist in responding to emergency call-outs on station trouble and coordinating prompt restoration of service to customers as required. The following list sets forth the principal duties required with the degree of supervision normally given. This list is not intended to limit assignment of work or the degree of supervision under all operating conditions. Employee may perform miscellaneous, related, and incidental work in addition to that specifically outlined below.

Station Servicer C - Station Servicer:

What You'll Do:

• Work on energized equipment up to 260 volts. After six months in classification, employee shall assist in work on conductors and equipment energized at voltages above 750 volts with direct supervision or assistance of personnel in higher classification.
• Select proper prints and/or drawings for various work and have a basic understanding of each.
• Use voltmeters, ohmmeters, ammeters, insulation meggers and other test equipment associated with station work.
• Assist in disassembling and reassembling, inspecting, maintenance, and repairing of station transformers, circuit breakers, portable substations, rotating machinery, network protectors and transformers, air ducts and heat exchangers; install and maintain station batteries; replace nitrogen bottles and air filters.
• Assist in station work such as installing conduit, pipe, cable and wire; use hand lines to pass tools and materials; dig and backfill trenches; remove and spread stone; uncrate equipment and material; install and remove portable substation fences, barriers and safety signs; paint structures and equipment; climb station structures.
• Use various kinds of tapes, insulating materials, protective and insulating paints and varnishes, and understand proper application of each.
• Assist in making visual inspections such as check lights, heaters, circuit breaker counters, oil levels, and bus connections; read gauges such as voltmeters, ammeters, hydrometers, pressure and level gauges; apply start- run-stop tests on emergency generators, water and sump pumps and fire engine motors. Report abnormal conditions.
• Replace lamps, switches, duplex outlets, dry cells; install and maintain signal and communication systems.
• Assist in various tests involving oil samples, connecting and operating portable and stationary oil handling equipment. Assist in electrical tests, TTR, Doble, core megger and resistance for transformer testing, etc.
• Become familiar with Company DC Supply Procedures to ensure NERC Compliance and proper equipment operation. Assist area personnel on DC Supply Installations and repair work while ensuring proper documentation.
• Become familiar with Company Station Communication System Procedures to ensure NERC Compliance and proper equipment operation. Assist area personnel while performing inspections on such equipment. Station Communication equipment consists of radios, carrier current, telemetering, pilot wire and control equipment, and other required communication systems identified by NERC.
• Assist in station switching including use of radio communication and/or direct instruction from higher classification, assist in checking equipment clearances and making de-energized tests, place grounds as directed.
• Gain knowledge and proficiency in steel and aerial lift rescue.
• Maintain records and prepare and submit reports as required.
• Attend and participate in training and assist in the training of other employees as assigned.
• Use and operate various company vehicles, specialized equipment, hand and power tools.
• Operate company vehicles, cranes, aerial lifts and specialized equipment. Perform duties incidental to the operation of such equipment
• Use hand and power tools; operate portable generators, blowers and pumps; inspect and store personal protective equipment.
• Knowledge and use of various knots used in station work.
• Perform similar or less skilled work as assigned
• Assist employees of equal or higher classification; direct the work of employees assigned to assist.
• Become familiar with the Company's safety rules and practices

What We're Looking For:

Station Servicer C:

Education requirements are listed below:

• Associate degree in electrical/mechanical/industrial maintenance technology or equivalent education and/or experience.
• Equivalent education and experience is limited to military training and work experience of technical/technician nature(such as aviation and nuclear instrumentation technician); or recent experience (within last 6 months) as a Station Electrician or equivalent job title with another utility or contractor.

Work Experience requirement listed below:

• No previous work experience required.

Required License(s)/Certification(s) are listed below:

• Must possess and maintain a valid commercial driver license.
• Must meet all vehicle operation requirements as designated by federal and/or state law.

Other Requirements:

• Knowledge of print reading sufficient to interpret and apply information from drawings, instruction manuals, one-line diagrams, and associated documents.
• Must satisfactorily complete, in such time frames as may be established by the Company, all required training to advance to the next higher classification in the line of progression or vacate the current classification.
• Must have the ability and desire to acquire the necessary knowledge and skills to perform the duties and/or responsibilities of the key job (Station Servicer) in this family and be qualified through demonstration, examination and/or performance appraisal as determined by the Company.
• Ability to deal with customers and other employees in a courteous and professional manner.
• Ability to plan work and to properly instruct and brief others. Employee shall obtain the appropriate valid commercial driver's license prior to the end of the designated probationary period.
• Must meet all vehicle operation requirements ad designated by federal and/or state law.
• Employee Shall spend approximately 25% of their time working with an employee performing station inspections, by assisting in station facility inspections, switching, and call-outs at station facilities.
• Considerable travel and overtime may be required to complete work assignments.
• Must successfully complete the Physical Abilities Test(PAT)
• Exposure to environmental conditions such as weather, hazardous conditions and uneven terrain
• Working at heights, climbing ladders and frequent walking
• Ability to operate vehicles, heavy equipment and mechanized devices
• Occasional lift up to 65 pounds and frequently lift up to 50 pounds.

Drive Time Requirement:

• Successful candidate must live or be willing to relocate within 45 minutes of the Marietta Service Center (300 B.F. Goodrich Rd Marietta, Ohio 45750)

What You'll Get:

Station Servicer C: $31.33 - $34.84

Station Servicer B: $40.39 - $41.60

Station Servicer: $60.86

In addition to a competitive compensation, AEP offers a unique comprehensive benefits package that aims to support and enhance the overall well-being of our employees.

At AEP, we're more than just an energy company we're a team of dedicated professionals committed to delivering safe, reliable, and innovative energy solutions. Guided by our mission to put the customer first, we strive to exceed expectations by listening, responding, and continuously improving the way we serve our communities. If you're passionate about making a meaningful impact and being part of a forward-thinking organization, this is the company for you!

Compensation Data

Compensation Grade:

U018-150

Compensation Range:

$31.33 - $60.86

The Physical Demand Level for this job is: H Heavy Work: Exerting 50 to 100 pounds of force occasionally, and/or 25 to 50 pounds of force frequently, and/or greater than negligible up to 10-20 pounds of force constantly to move objects. Physical demand requirements are in excess of those for Medium Work.

It is hereby reaffirmed that it is the policy of American Electric Power (AEP) to provide Equal Employment Opportunity in all respects of the employer-employee relationship including recruiting, hiring, upgrading and promotion, conditions and privileges of employment, company sponsored training programs, educational assistance, social and recreational programs, compensation, benefits, transfers, discipline, layoffs and termination of