Maintenance Technician I - 2nd Shift

Job Summary Maintain and repair mechanical and electrical systems within a manufacturing environment; execute capital projects (installation, dismantling of equipment) and other various maintenance tasks throughout the facility. Expected hours of work 40 hours a week with a varied shift schedule 10+ hours shifts with occasional overtime and weekend hours. No travel required. Duties and Responsibilities: Reassemble machines after the completion of repair or maintenance work. Start machines and observe mechanical operation to determine efficiency and to detect problems. Inspect or test damaged machine parts and mark defective areas or advise supervisors of repair. Lubricate or apply adhesives or other materials to machines, machine parts, or other equipment according to specific procedures. Install, replace, or change machine parts and attachments according to production specifications. Dismantle machines and remove parts for repair using hand tools, chain falls, jacks, cranes, or hoists. Record production, repair, and machine maintenance information. Read work orders and specifications to determine machines and equipment requiring repair or maintenance. Set up and operate machines and adjust controls to regulate operations. Transport machine parts, tools, equipment, and other material between work areas and storage, using cranes, hoists, or dollies. Collect and discard worn machine parts and other refuse to maintain machinery and work areas. Clean machines and machine parts, using cleaning solvents, cloths, air guns, hoses, vacuums, or other equipment. Other duties as assigned. Required Knowledge / Skills/Abilities: Knowledge of measuring gauges such as tape measures Knowledge and use of micrometers and calipers. Knowledge of various hand and power tools Prior experience operating a forklift. Ability to comprehend complex technical topics and specialized information. Effective communication and problem-solving skills Understanding of basic math, reading, and writing skills Ability to work under pressure to complete assigned tasks under stressful situations. Ability to use hand & portable tools, gas and arc welder, forklift, pickup truck, testing equipment, tape measure, computer (shop floor and ERP). Ability to obtain rigging training and certification (as needed). Ability to obtain welding certification (as needed). Education and Experience: Required: Education – High School diploma or GED required. Must complete NFPA 70E training within 180 days of assignment. One to two (1-2) years related maintenance experience. Previous experience in the following maintenance areas preferred: electrical, plumbing, carpentry, and welding. Mechanical background with rotating equipment. Hydraulic and pneumatic. Electrical/mechanical troubleshooting. Working Conditions: Fast paced manufacturing environment where workers are exposed to both ambient/outside temperatures and dust; working with mechanical parts and pinch points; exposure to increased noise levels. Exposure to hazardous mechanical, electrical and chemical substances/equipment. Confined workspaces. Physical Requirements OCCASIONALLY (0-30%) FREQUENTLY (31-60%) CONTINUOUSLY (61-100%) LIFTING OR CARRYING 1-10 LBS 11-20 LBS 21-40 LBS 41-50 LBS 51 OR MORE LBS PUSHING OR PULLING 1-40 LBS 41-50 LBS 51 OR MORE LBS REACHING ABOVE SHOULDER LEVEL DRIVING AUTOMATIC EQUIP. VEHICLES OPERATE MACHINERY OR POWER TOOLS CLIMBING (LADDERS, STAIRS, ETC.) WALKING STANDING SITTING WORKING IN EXTREME TEMPERATURES REPETITIVE MOTION INCLUDING BUT NOT LIMITED TO: WRISTS, HANDS AND/OR FINGERS) VISION HEARING DEXTERITY HAND EYE COORDINATION Personal Protective Equipment (PPE) Used: Eye and hearing protection is required at all times on the production floor. Safety toe shoes (steel/composite). Flame Resistant rated Maintenance uniform provided. Other PPE as defined by management within assigned department. #J-18808-Ljbffr