Painter

Painter

The Painter is responsible for surface preparation and painting of fabricated parts, assemblies, and materials produced in the fab shop. This role supports production schedules by delivering consistent, high-quality finishes while following all safety, environmental, and quality standards.

Responsibilities:

• Prepare surfaces for painting, including cleaning, degreasing, sanding, grinding, masking, and priming, as required by the material and finish specification.
• Apply paint, primer, and coatings to a wide variety of materials and components using spray equipment, rollers, and brushes.
• Inspect finished work for quality, coverage, and appearance, and correct defects such as runs, drips, or uneven coating.
• Mix, thin, and prepare paints and coatings according to manufacturer specifications and work instructions.
• Read and follow work orders, drawings, and finish specifications to ensure parts are painted correctly and on schedule.
• Set up, operate, clean, and perform routine maintenance on spray equipment, booths, and related tools.
• Handle, store, and dispose of paints, solvents, and hazardous materials in compliance with safety and environmental regulations.
• Properly handle and stage parts before and after painting to prevent damage and allow for adequate curing time.
• Maintain a clean, organized, and safe work area, including the paint booth and prep areas.
• Coordinate with fabrication, machining, and assembly personnel to meet production priorities.
• Wear and maintain required personal protective equipment (PPE), including respirators, and follow all safety procedures.
• Perform other duties as assigned.

Minimum Qualifications:

• High school diploma or equivalent.
• Experience in industrial painting, coating, or surface preparation preferred.
• Working knowledge of spray painting equipment and techniques.
• Ability to read and interpret work orders, drawings, and finish specifications.
• Knowledge of shop safety practices and handling of hazardous materials.
• Ability to pass a respirator fit test and medical clearance as required.
• Strong attention to detail and commitment to quality workmanship.
• Ability to work independently and manage priorities in a production environment.

Physical Demands:

• Ability to lift and carry up to 50 lbs.
• Frequent standing, walking, bending, kneeling, reaching, and working in awkward positions.
• Ability to wear a respirator and required PPE for extended periods.
• Exposure to paint fumes, dust, solvents, noise, and temperature variations in a shop environment.

Magnum Venus Products, Inc. is committed to compliance with its obligations under all applicable state and federal laws prohibiting employment discrimination. In keeping with this commitment, it attempts to reasonably accommodate applicants and employees in accordance with the requirements of the disability discrimination laws. It also invites individuals with disabilities to participate in a good faith, interactive process to identify reasonable accommodations that can be made without imposing an undue hardship.

Magnum Venus Products, Inc. is an Equal Opportunity Employer