PLC Technician

Essential Duties and Responsibilities: Write, change, and test control programs in Opto 22 PAC Control (flowcharts and OptoScript) on groov EPIC and SNAP PAC controllers for new equipment and line changes. Support and troubleshoot Allen-Bradley PLCs (RSLogix 500 / Studio 5000) on the equipment that uses them. Update HMI screens (groov View / PAC Display), alarms, and operator messages. Load and start up program changes on running lines without causing unplanned downtime. Keep a current, labeled backup (date, reason, name) of every controller and HMI program, and fix any mismatch with the running program. Set up and tune VFDs, sensors, and scales. Read schematics and build, wire, and terminate control panels and field devices. Run conduit and cable to plant and food safety standards, and check all wiring against the print before powering up. Mark up prints when field wiring doesn't match the drawing and submit the change. Install and test safety devices such as e-stops, light curtains, and safety relays. Respond to line-down calls, find the cause (electrical, mechanical, or logic), and get the line running again. Record the cause and fix in the maintenance system, and recommend permanent fixes for repeat problems. Complete scheduled inspections of panels, drives, and sensors. Always follow lockout/tagout, NFPA 70E arc flash rules, GMPs, SQF, and sanitation rules. Train operators and maintenance staff on common faults and recovery steps. Education and/or Work Experience Requirements: 3+ years of hands-on PLC work in a manufacturing or processing plant Opto 22 programming experience (PAC Control, groov EPIC or SNAP PAC), or strong PLC programming experience and the ability to learn Opto 22 Able to read schematics and I/O drawings and wire control panels and field devices NFPA 70E / arc flash training, or complete it within 60 days of hire LOTO-qualified, or become qualified within 30 days of hire High school diploma or GED Available for overtime, weekends, callouts, and on-call rotation, especially during harvest season California electrician certification is not required. Preferred: Allen-Bradley RSLogix 500 / Studio 5000 experience groov View, Ignition, or other HMI/SCADA experience VFD setup experience Food, beverage, or fresh-cut processing experience Technical degree or certificate in automation, electronics, or a related field Bilingual English/Spanish Physical Requirements: Work in wet, cold (34–45°F), loud production areas Stand and walk most of the shift; lift and carry up to 50 lbs Bend, kneel, reach overhead, and work in tight spaces Climb ladders, work from lifts, and enter confined spaces with a permit Wear required PPE, including hearing protection, arc flash gear, and food safety garments #J-18808-Ljbffr