Re-Cutter

Job Description

Job Description

All the items listed below are to be followed by the Line 8 Winder Operator. This is a detailed list of what your job is and what is expected of you as an employee. Primary responsibilities should take place before secondary responsibilities unless otherwise instructed.

Primary Responsibilities

• Read work orders.
• Check equipment before operating (Blades, Tooling…).
• Set up machine for the current job.
• Change blades throughout production when cuts start to go bad.
• Make a notice when blades are running low.
• Tag boxes correctly and fill out load tags for what product is going on that specific pallet.
• Keep production running smoothly.
  • Replace boxes right after they fill.
  • Build boxes while waiting for the machine to fill the current one.
• Keep a clean and organized area.
• All other assigned duties

Secondary Responsibilities

• Sweep around machine.
• Blow out the inside and underneath the machine.

Physical demands: Standing : Prolonged periods of standing on production floor (up to 8–10 hours per shift). Walking : Frequent walking around production and packaging areas. Lifting : Occasionally lift and move products or materials up to 25–50 lbs. Bending/Stooping : Regular bending to inspect lower-level machinery or products. Reaching : Frequent reaching over and around equipment or conveyors. Climbing : Occasionally climb steps or ladders to access equipment or inspection points. Repetitive Motions : Repetitive hand and arm movements when conducting tests or entering data.