Maintenance Tech III

SummaryMaintain and service plant operating equipment, HVAC, electrical, and in-plant general necessities. Other duties may be assigned. **This position will begin through a staffing company**Essential Duties and ResponsibilitiesReceives and carries out instructions for jobs from area supervisor or leadmanProvide emergency/unscheduled repairs of production equipment, and facility/building issuesKnowledge of 110v, 240v, and 480v systems and low voltage controlsAble to read and understand schematicsAbility to program and service PLC’s, plus read and understand ladder logicAbility to troubleshoot electrical problemsWorking knowledge of hydraulic systemsWorking knowledge of pneumatic systemsWorking knowledge and proper use of all hand toolsAbility to weld and fabricate items with mig and arc weldingWorking knowledge and use of all meters and gauges needed to perform all dutiesAbility to work with minimal supervisionFollow and or assist in development of Preventive and Predictive Maintenance ProgramsComply with OSHA Safety and Health rulesFollow all safety procedures and report any hazards immediatelyMaintains a clean and orderly work areaMeet or exceed maintenance standardsMust be able to work scheduled shift as well as overtime & weekends as requiredMust be able to work as a member of the teamOther duties as assignedQualificationsThe requirements listed below are representative of the knowledge, skill, and/or ability required. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions. Understanding of all mechanical equipment and its maintenance needs. Must be able to inspect parts for conformance.Education and/or ExperienceMinimum 10 years of maintenance experience and or an Associate’s degree in Electrical Studies or apprenticeship programHigh school diploma or general education degree (GED) preferredReasoning AbilityAbility to apply common sense understanding to carry out a repair, maintenance and service situation. Ability to deal with non-standardized situations on as daily basis. Ability to use standard instructions provided by manufacturers of plant equipment, and install/repair plant equipment.Physical DemandsThe physical demands described here are representative of those that must be met by an employee to successfully perform the essential functions of this job. Employee must be able to perform tasks such as: climbing a ladder, use of aerial platforms, repetitively pushing or pulling with arms in any position including overhead, and lifting 50 pounds intermittently as needed. The employee must have a reasonable range of motion and strength of all extremities and spinal segments as determined by a physical exam. Specific vision abilities required by this job include close vision, distance vision, color vision, peripheral vision, depth perception, and ability to adjust focus.Work EnvironmentThe work environment characteristics described here are representative of those an employee encounters while performing the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions. The noise level in the work environment is usually loud. We are not a climate-controlled facility; therefore, summer heat and winter cold are conditions that should be expected. #J-18808-Ljbffr