Sheet Metal Ductwork Installer

Sheet Metal Installer Employment RequirementsKnowledge and Skills Read basic HVAC plans and shop drawings Lay out and install rectangular, round, spiral, and flex duct Install fittings, dampers, access doors, grilles, registers, and diffusers Measure, cut, modify, and assemble sheet metal Seal ductwork with approved mastic, tape, and sealant Install duct hangers and supports correctly Use hand tools, drills, saws, snips, and power tools safely Understand basic duct sizes, airflow direction, and system layout Work from ladders, scaffolds, and lifts Follow OSHA and jobsite safety requirements Coordinate with supervisors and other trades Perform quality work with minimal supervision Keep the work area clean and organized Required Tools and Equipment Tape measure Marker and pencil Aviation snips Sheet-metal hammer Hand seamers Crimpers Folding bar Utility knife Cordless drill and impact driver Drill bits, nut setters, and driver bits Level Adjustable wrench and basic hand tools Tool pouch or tool bag Safety glasses Work gloves Hard hat High-visibility vest or shirt Steel-toe or safety-toe work boots Employment Requirements Valid driver’s license and reliable transportation Ability to arrive on time and work a full schedule Ability to lift approximately 50 pounds Ability to work in hot, confined, and elevated areas Legal authorization to work Reliable phone and communication Willingness to travel to different jobsites Ability to pass required background checks or drug testing OSHA 10 certification preferred Lift certification preferred Previous commercial HVAC installation experience preferred #J-18808-Ljbffr JAMCO AC INC.