INSTRUMENT MECHANIC

Summary You will serve as a INSTRUMENT MECHANIC in the JBPHH UTILITIES DIVISION of NAVAL FACILITIES ENG COMMAND HAWAII. Responsibilities You will maintain parts, materials, tools, and equipment at prescribed levels for instrument work. You will calibrate and maintain cleanliness of test instruments used in wastewater systems You will inspect, test, modify, and calibrate Supervisory Control and Data Acquisition Systems (SCADA) to maintain operational efficiency. You will repair mechanical, electronic, physical, and electro-mechanical test devices or instruments used to measure equipment at a wastewater lift station. You will use shop mathematics (e.g., algebra, geometry, basic physics) relating to electrical and electronic functions to accomplish initial operational checks and the calibration and final testing of instruments and equipment. Requirements Conditions of Employment Qualifications Although a specific length of time and experience is not required for most trade and labor occupations, you must show through experience and training that you possess the quality level of knowledge and skill necessary to perform the duties of the position at the level for which you are applying. Qualification requirements emphasis is on quality of experience, not necessarily the length of time. Your qualifications will be evaluated on the basis of your level of knowledge, skills, abilities and/or competencies in the job elements and screen out listed below. This job has a screen-out element which will be used to determine minimum eligibility for this job. Applicants who do not receive a minimum of two points on the screen-out element(s) will be found ineligible. The Screen-out Element for this position is ABILITY TO DO THE WORK OF THE POSITION WITHOUT MORE THAN NORMAL SUPERVISION: 1) Must have experience and knowledge with maintaining mechanical and electrical systems. 2) Must have experience with trouble shooting electrical systems. 3) Must posses basic knowledge of electrical systems. I work under close supervision of a work leader or journey-level employee who observes tasks in progress and upon completion to make sure they are properly performed. NOTE This information must be supported by your resume in order to be considered for this position. Applicants must meet the requirements of the Office of Personnel Management (OPM) Job Qualification Handbook for Trades and Labor Occupations. Additional qualification information can be found at: Experience refers to paid and unpaid experience, including volunteer work done through National Service programs (e.g., professional, philanthropic, religious, spiritual, community, student, social). Volunteer work helps build critical competencies, knowledge, and skills and can provide valuable training and experience that translates directly to paid employment. Education Additional Information This position is covered by the Department of Defense Priority Placement Program. A tentative offer of employment will be rescinded if the selectee fails to meet the pre-employment requirements, including failure to report to any of the scheduled appointments. Selectee occasionally lifts and carries weights up to 50 lbs. Work involves standing, and sitting positions for continuous periods as well as frequent bending, kneeling, stooping, and crouching. Works occasionally involves fumes and unpleasant odors (e.g. cleaning solvents and preservative sprays). Also is intermittently exposed to common electrical/mechanical industrial hazards. Occasionally works in confined dark spaces. Employee may be required to work overtime, is subject to emergency recall seven days a week and is subject to shift work. Selectee may be required to perform off-station and off-Oahu "on-site" work assignments. These work assignments may involve working in hazardous duty areas and the working of irregular hours. Temporary duty assignments will involve travel by commercial or military aircraft and surface craft for training and development purposes. Occasionally assigned duties will require selectee to enter into and work inside confined spaces. Selectee will be required to receive a pre-placement physical examination based upon the type of work performed and hazards to be encountered, an annual examination based on the potential of these hazards and a termination examination upon termination of employment or reassignment to other duties. Federal annuitant information: The selection of an annuitant is subject to the Department of Defense and Department of the Navy policy on the employment of annuitants. Policy information may be found at: PPP applicants will be placed at the FPL, if determined Well Qualified (WQ). To receive priority consideration, the FPL must be the same grade level or equivalent of the retained grade or the grade held immediately prior to separation. ICTAP Applicants: To be considered well-qualified and exercise selection priority as an ICTAP candidate, displaced Federal employees must satisfy all qualification requirements for the position and receive a rating in the highly qualified category (score 85) or higher. ICTAP candidates must provide copies of all of the following documentation at the time of application: 1) agency notice; 2) most recent performance appraisal; and 3) most recent SF-50 or notification of personnel action that includes position, grade level, and duty location. Applicants who do not provide this documentation will not receive consideration as an ICTAP candidate. For more information about ICTAP eligibility please review the following link: Military Spouse Preference applicants will be placed at the highest grade for which they have applied and are determined Best Qualified (BQ). A BQ military spouse possesses knowledge, skills, abilities, and competencies comparable to others who meet the competitive referral criteria for the specific position.