Hone and Lap - Machinist A

Hone And Lap - Machinist A

Eaton's IS AER FMC division is currently seeking a Hone and Lap - Machinist A. The core hours are 1:45pm to 10:15pm. The hourly rate for this position is 34.51 - 51.77 per hour. Please note the salary information shown above is a general guideline only. Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations.

What You'll Do:

Eaton Aerospace Group located in Los Angeles, CA (near Glendale metro) has an opening for a Machinist A. The LA facility has approximately 250 employees and is a leader in the design, development, manufacture and delivery of Aerospace hydraulic components, systems and services to the global aftermarket and OEM markets.

• Capability to setup complex parts and operate machine without supervision.
• Interprets plans, work order, blueprints or drawings to determine the necessary work required, full understanding of GD&T.
• Inspects parts for quality and appropriate tolerance using the appropriate measuring tools such as micrometers, calipers, air gages and comparators.
• Finishes all parts with different materials to close tolerance without supervision.
• Examines surface of work piece for defects before starting work.
• Meet production and quality requirements at all times, always keep work area clean.
• Modify machining feed and speeds on multiple material types and select tooling, gauges as/if required.
• Use measuring tools, air gauges, micrometers and other inspection tools to verify part quality.
• Replaces worn tools, inspect parts and adjust tool offsets as needed.
• Drives for continuous process improvements

Qualifications:

Basic (Required) Qualifications:

• Must have a high school diploma or GED from an accredited institution.
• A minimum of seven (7) years experience in machining, honing or lapping parts in a manufacturing environment.
• Eaton will not consider applicants for employment immigration sponsorship or support for this position. This means that Eaton will not support any CPT, OPT, or STEM OPT plans, F-1 to H-1B, H-1B cap registration, O-1, E-3, TN status, I-485 job portability, etc.
• No relocation benefit is offered for this position. Only candidates residing within the immediate area of Los Angeles, CA (50 miles) will be considered for this position.
• This position requires access to export-controlled information. To conform to U.S. Government export regulations applicable to that information, applicant must be a U.S. person, defined as a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (green card holder), (iii) refugee under 8 U.S.C. 1157, or (iv) asylee under 8 U.S.C. 1158.

Preferred Qualifications:

• Aerospace experience.
• 8 plus years experience in machining, honing or lapping parts in a manufacturing environment.
• Involvement in successful process definition and re-engineering.
• Experience in employee involvement in multi-discipline teaming.
• Proficiency with computer based methods and tools.
• Familiarity /experience with Lean Manufacturing, Kaizen events, and continuous improvement and Six Sigma methodology.

Position Criteria:

• Experienced with multiple machine tools, production methods and shop practices preferred.
• Ability to learn equipment and processes for fabrication of aerospace parts, produce parts in accordance with the production plans, sketches and/or verbal instructions.
• Ability to maintain close tolerance dimensions on critical parts.
• Knowledge of dimensional measuring instrumentations and use of such tools to verify actual measurements of machined diameters, dimensions and features.
• Ability to read and interpret drawings, sketches, manufacturing routings, procedures, and routers.
• Good verbal and written communication skills a must.
• Familiarity with SPC principles and methods.
• Ability to produce and inspect critical parts with tight tolerances and finishes, with minimal supervision.
• Ability to logically solve problems and to keep assignments and projects moving in an orderly and structured fashion.