Drawing Quality Checker

Job Description: JOB SUMMARY
Primarily performs in process and final inspection of new and repaired sub assemblies, assemblies, and electronic systems. Using standard inspection devices and/or elementary testing equipment, and following prescribed inspection procedures, sets up, checks and visually inspects bench-assembled production components and subassemblies for conformance to predetermined electronic standards, specifications or tolerances in accordance with IPC-A-610 and JSTD-001. Works from production schematics, drawings, shop orders, specifications, and blueprints and uses precision measuring instruments to check dimensional accuracy of products. Does all type of electronic inspection, and some mechanical inspection, for Receiving, In-process, and Final Inspection.

ESSENTIAL DUTIES & RESPONSIBILITIES

Examines layout and installation of wiring, cables, subassemblies, hardware, and components to detect assembly errors.

Compares assembly with parts list to detect missing hardware.

Visually examines joints, wires and cables to locate soldering defects.

Examines alignment of parts and measures parts for conformance to specified dimensions.

Twists dials, knobs, shafts, and gears to verify freedom of movement.

Traces cables and harness assemblies, following cable wiring diagram, to verify routing of wires to specified connections and conformance of cable lacing and insulation to manufacturing standards.

Examines plated areas for uniformity and thickness.

Performs 1st article inspection of sub assemblies and assemblies.

Examines parts for surface defects such as chips, scratches, and pinholes.

Witnesses in process and acceptance testing of assemblies and systems.

Examines production documents to ensure that all assembly, inspecting, and testing steps were performed according to specifications.

Calculates percentage of defective parts.

Records inspection data such as serial number, type and percent of defects, and rework required.

NON ESSENTIAL DUTIES

Light housekeeping in inspection department, keeping inspection equipment and work stations clean.

Performing such duties as filing and copying, and other tasks as assigned by the inspection supervisor.

QUALIFICATION REQUIREMENTS (Skills, Knowledge and Abilities required)
High school diploma or general education degree (GED), and 3 to 6 years related electronics inspection experience and some mechanical inspection experience required.

J-STD-001 Certification preferred.

LANGUAGE SKILLS

LEVEL 3: Ability to read and interpret documents such as safety rules, operating and maintenance instructions, and procedure manuals. Ability to write routine reports and correspondence. Ability to speak effectively before groups of customers or employees of organizations. Ability to communicate in English.

Must be able to adequately communicate with coworkers. Good written and verbal communication skills in English required.

MATHEMATICAL SKILLS

Ability to add, subtracts, multiply and divide in all units of measure, using whole numbers, common fractions, and decimals. Ability to compute rate, ratio, and percent and to draw and interpret bar graphs.

REASONING ABILITY

Ability to apply commonsense understanding to carry out instructions in written, oral or diagram form. Ability to deal with problems involving several concrete variables in standardized situations.

Ability to complete tasks in a timely manner, pay close attention to detail, and produce high level of accuracy.

#J-18808-Ljbffr CorTech International