Electronics Calibrator

Talent Acquisition Specialist at SIMCO Electronics
The Calibration Technician C will apply knowledge of measurement science, mathematics, physics, and electronics to calibrate inspection, measurement, and test equipment in the Acoustical, Chemical, Dimensional, DC/Low Frequency, RF/Microwave, Fluid, Mechanical, Optical, Thermodynamics, and Time & Frequency disciplines to ensure measurement accuracy. The Calibration Technician C will identify and utilize appropriate manual and automated measurement procedures.

This position will normally receive no instruction on work, applying job skills and company policies and procedures to complete a wide range of difficult tasks, and working on assignments that are moderately complex in nature where judgment is required in resolving problems and making routine recommendations. The Calibration Technician C will perform laboratory housekeeping and may perform some administrative duties. The Calibration Technician C may be asked to report opinions and interpretations.

Calibrate inspection, measurement, and test equipment (IM&TE) in one or more of the following disciplines - Acoustical, Chemical, Dimensional, DC/Low Frequency, RF/Microwave, Fluid, Mechanical, Optical, Thermodynamics, and Time & Frequency, in order to ensure compliance with published specifications

Perform maintenance, troubleshooting and repair of precision equipment

Collect, compile, measure, summarize, and record data gathered during calibration.

Adapt existing calibration equipment, standards, and techniques to accomplish unique measurements tasks for which they are not principally used.

Perform uncertainty evaluation and analysis for measurement standards and associated measurement processes.

Interact with other technicians, Customer Service Representatives, Account Managers, and customers.

Minimum High School diploma or equivalent.

Technical writing ability.

Intermediate ability to troubleshoot repair, align and optimize precision equipment.

Proficient in use of MS Word and Excel.

Minimum three years of calibration experience some of which can be offset with formal metrology training.

Knowledge of Quality Management system (ISO 9001, ISO 17025 and ANSI Z540).

Must have great interpersonal and customer service skills.

Must be able to lift up to 45 pounds without assistance.

Works primarily in a laboratory or manufacturing environment at a SIMCO location and/or customer sites.

Travel is required to other domestic and possibly international locations.

SIMCO provides equal employment opportunities (EEO) to all employees and applicants for employment without regard to race, color, religion, sex, national origin, age, disability or genetics. In addition to federal law requirements, SIMCO complies with applicable state and local laws governing nondiscrimination in employment in every location in which the company has facilities. This policy applies to all terms and conditions of employment, including recruiting, hiring, placement, promotion, termination, layoff, recall, and transfer, leaves of absence, compensation and training.

Full‑time

Manufacturing

Appliances, Electrical, and Electronics Manufacturing

Medical Equipment Manufacturing

Aviation and Aerospace Component Manufacturing

#J-18808-Ljbffr SIMCO Electronics