Assembler II (1st shift) - Cable Tray

Assembler II (1st Shift) - Cable Tray

Eaton's ES GEIS BLD division is currently seeking a Assembler II (1st shift) - Cable Tray at our Reno, NV location! The hourly rate for this position is $22.73 per hour.

CORE HOURS: 6:15AM - 2:30PM

Please note the salary information shown above is a general guideline only. Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations.

What You'll Do:

The Assembler II position is primarily focused on assisting and setting up for Welders in the Cable Tray department. The Assembler II will assemble and stack/band Cable Tray ladders. The Assembler II will handle materials and parts up to 50-pounds frequently throughout the shift.

• Perform simple repetitive assembly of parts and components
• Use bolts, screws, hand tools, clips and other fastening devices
• Work under close supervision and may work from models, samples, or simple diagrams
• Handle 50-pound parts to assist with large part construction
• Support all facility Continuous Improvement and LEAN initiatives including, but not limited to:
• Maintain 5-S (sort, set in order, shine, standardize, sustain) throughout shop floor and office areas.
• Track and sustain all visual management tools such as, but not limited to: layered audits, Overall Equipment Effectiveness (OEE) boards, and any additional LEAN tools that are deemed necessary to provide direction, goals and status to the shop floor.
• Encourage, support, and actively participate in Kaizen improvements and events throughout the facility, department, and area of responsibility.

Position Success Criteria:

• Consistently lift 50 pounds
• Able to stand on feet continuously during working shift.
• Must be able to wear required personal protective equipment as required by company policy and procedure.
• Must be able to handle materials up to 50 pounds
• Require fine manipulation of hands with repetitive motion.
• Troubleshoot and resolve problems as they arise.
• Handle materials that pertain to large part construction, weighing 50 pounds multiple times per day.

Qualifications:

Required (Basic) Qualifications:

• No relocation package offered. Candidates must reside within 50 miles of the work location to be considered for this position. Active-Duty Military Service member candidates are exempt from the geographical area limitations.
• Eaton will not consider applicants for employment immigration sponsorship or support for this position. This means that Eaton will not support any CPT, OPT, or STEM OPT plans, F-1 to H-1B, H-1B cap registration, O-1, E-3, TN status, I-485 job portability, etc.

Preferred Qualifications:

• Previous experience in a manufacturing environment
• Experience confirming that parts conform to specs using measuring tools.
• A minimum of 6 months of experience with forming or bending machines
• A minimum of 6 months of experience reading drawings or blueprints

Additional Information:

Physical Demands:

• Able to regularly lift 35 pounds without assistance; also lifting more than 50 lbs. with assistance.
• Exposure to high noise level (ear protection may be required in some areas).
• Exposure to high traffic areas with forklift activity.
• Work environment exposes to oils, lubricants, and solvents.
• Require fine manipulation of hands with repetitive motion

Working Conditions:

• Exposure to cold/heat weather conditions while roll-up doors are open
• Fast paced working, while maintaining safety priorities