Lead E&I Technician

Lead Electrical And Instrumentation Technician

WIN Waste Innovations is looking for a Lead Electrical and Instrumentation Technician to install, troubleshoot, clean, inspect, calibrate, and maintain electrical, instrumentation, and distributive control equipment throughout the facility in a safe and professional manner. Lead, guide, and direct tasks of electrical and instrumentation technician staff in plant.

Responsibilities:

• Monitors and maintains facility equipment to ensure safe and efficient equipment and facility operation.
• Performs electrical preventive, repair, and calibration maintenance procedures safely and professionally with minimal supervision in accordance with Federal and State Regulations, and Company Work Rules, Policies and Procedures.
• Leads, guides, and directs job tasks of other technicians. Prioritize work, schedule plans, and follow up on directed assignments.
• Initiates and completes work-orders, requisitions, and documents all critical and or pertinent information on a routine basis.
• Responds and reports to work during off hours when emergency repairs are required.
• Travels to other facilities with-in the Company when technical support is required.
• Takes proactive measures to address improvement opportunities.
• Assists in training other employees.
• Leads, guides, and directs those assigned to assist in the safe and efficient completion of maintenance tasks.
• Assumes increased levels of responsibility when required or requested. Performs lesser skilled duties when required or requested.
• Completes the Corporate and Plant Training Programs within the time frame prescribed.
• Identifies and effectively uses basic and precision measuring tools to calculate and determine lengths, surface areas, and volumes as necessary while performing maintenance tasks on a routine basis.
• Follows standard safety procedures, correct safety, and environmental hazards, and report them to the Shift Supervisor immediately. Reads, understands, and applies information such as, lockout/tagout procedures, safety rules, job hazard analyses, operating and maintenance instructions, and procedure manuals.
• Works overtime.
• Works rotating shifts.
• Communicates clearly and concisely both verbally and in writing; as well as communicate clearly whether using in-situ intercom system, two-way radio, or face to face.
• Anticipates typical problems, identify potential or recurring problems, and take appropriate action. Troubleshoots equipment, diagnose problems and repair.
• Operates other equipment including, but not limited to, industrial forklifts, manlifts, skid steer type loaders, and other mobile equipment.
• Proficient knowledge, skills and abilities required to properly identify and safely and effectively use and maintain hand tools and portable power tools on a routine basis while performing maintenance tasks.
• Perform additional duties/tasks as required by plant management.
• Maintain positive work environment by acting and communicating in a manner so that you get along with customers, clients, vendors, co-workers and management.

Qualifications:

• High school diploma or general education degree (GED) or equivalent.
• Minimum of 8 years' experience in the Industrial or Power Industry Electrical and Instrumentation Maintenance Field, or a minimum of 2 years' experience as a 1st class E&I Technician
• Licenses required as necessary to comply State, Environmental, and/or Federal regulatory agencies or if Electrician, licensed as necessary by State, Environmental, and/or Federal regulatory agencies.

Work Environment:

Listed below are key points regarding environmental demands and work environment of the job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions of the job.

• Noise in work environment

Physical Demand:

• Stand
• Sit for prolonged periods of time
• Walk
• Handle tools, equipment, fine motor skills
• Reach with hands and arms
• Climb and walk on heights often greater than 4 feet
• Stoop, kneel, bend, push, pull, crawl
• Ascend and descend stairs and stationary vertical ladders as part of normal work activity and emergency egress situations
• Lift 50 lbs.
• Move about all areas of the plant, including catwalks, deck grating, and uneven surfaces
• Close vision, distance vision, peripheral vision, depth perception, corrected or otherwise
• Operate a 1.5-inch fire hose operating at 125 psi line pressure to the extent required to extinguish fire
• Operate fire extinguishing equipment ranging from handheld extinguishers to 200 lb portable units
• Access confined spaces and pressure vessels through standard 12" by 16" manways

PPE Required:

Work in areas under adverse conditions that may require the donning and use of personal protective equipment including, but not limited to, the following with average fatigue:

• Negative pressure respirator
• Positive pressure respirator
• Self-contained breathing apparatus (steel or composite bottle)
• Hardhat
• Approved safety shoes
• Eye protection
• Rubber suit and gloves
• Chemical resistant suit
• Heat resistant outerwear
• Flame resistant outerwear
• Approved hearing protection
• Gloves
• Safety harness

What You'll Enjoy:

• Industry leading benefits
• Multiple and flexible medical plans
• Outstanding PTO program
• Floating Holidays
• Strong 401k program and company match
• Tuition reimbursement plan
• College loan reimbursement
• College scholarship program for dependents
• Parental Leave Program
• Inclusive culture
• Employee engagement events
• Employee resource groups

WIN Waste Innovations is a waste management company committed to delivering essential waste management solutions to customers and communities supported by our team of 2,300 employees. We believe in preserving our environment for future generations while providing for today's needs. WIN Waste Innovations is a vertically integrated business with a platform of 50 strategically located collection, transfer, and disposal assets. These include waste-to-energy facilities, transfer stations, ash monofills, landfills, and fleets of rail cars and collection vehicles. We process more than 11 million tons of waste annually, converting 6.7 million tons of waste into clean, renewable energy that powers 340,000 homes. We recycle more than 234,000 tons of plastic, paper, and metals from the waste stream.

At WIN Waste Innovations, each eligible employee receives a competitive total compensation package including Medical, Dental, Vision, Life Insurance and Short-Term Disability. As well as Company match on 401K, and more! Our employees also receive Paid Vacation, Holidays, and Personal Days. Please note that benefits may vary by site. Equal Opportunity Employer Minorities/Women/Protected Veterans/Disabled.