Fixture Technician

$21.75 - $32.50/hour; pay based on qualifications and experience Working in accordance with verbal and written instructions and established procedure, and as assigned by the supervisor, perform a variety of duties. Must be able to read and understand blueprints and weld symbols. Working from prints, sketches, and instructions given, construct a variety of welding jigs and welding fixtures necessary to produce finished parts per specifications given using a variety of machine tools and precision measuring devices. Determine material requirements and requisition material as required. Maintain, repair, adjust or replace tooling associated with fixtures. Maintain computer records on all welding jigs and fixtures including their location and costs and activities. All of these records must be updated and supplied to the Welding Supervisor on a regular basis. Jigs and fixtures shall be designed, built, labeled and guarded to meet OSHA requirements and Patz Corporation, Inc. standards. Ergonomic factors along with production standards shall be considered in the design and construction of all jigs and fixtures. Assist welders in set up as required and when trouble shooting die and jig problems. Pull welding jigs and fixtures as required for production and inspect before use and prior to putting away at end of production run for damage and wear. Check all machine tools for proper operation and report any malfunctions to the Welding Supervisor. Maintain a clean and orderly work area. Education Requirements Should be able to read and understand drawings, shop mathematics, handbook formulas, and a variety of precision measuring instruments. At least one year experience welding or welding course. Must be able to work from detailed instructions. Must be able to pass a basic weld test. Physical Demands In an 8-hour day the employee must stand/walk 6-8 hours and sit 1-4 hours. Must frequently use hand(s) for repetitive movement single grasping, and occasionally pushing, pulling, and fine manipulation. Must occasionally use foot/feet for repetitive movement as in operating foot controls. Must frequently bend, twist, and reach, and occasionally squat. Must perform Light Heavy Work, lifting 75 pounds maximum with frequent lifting and carrying of objects weighing up to 40 pounds. Typical Working Conditions Located in a factory setting with a large amount of noise and distractions. Personal Protective Equipment (PPE) required at all times in all manufacturing areas Safety glasses with side shields. Hearing protection. Long work pants. Personal Protective Equipment (PPE) for occasional activities for this job description: Hard hat (where overhead hazards exist). Protective gloves (when welding & material handling). Shaded lens goggles or glasses (torching operations). Safety goggles or face shield (abrasive disk grinder use). Safety Observe all safety rules and corporate policies. Confidentiality Employee shall not, either during the period of employment or thereafter, except where authorized or directed by Patz in writing, disclose to others either verbally, electronically, or otherwise, use for employee’s own benefit, copy, or make notes of any confidential information or trade secrets other than that which is in public knowledge, of or relating to Patz’ business, which may come to employee’s knowledge during employment with Patz. Affirmative Action Patz Corporation is an Affirmative Action/Equal Employment Opportunity Employer/Vets/Disabled #J-18808-Ljbffr Patz Corporation