SAW OPERATOR

Saw Operator The Saw Operator is responsible for accurately cutting tube and rod materials according to job specifications while maintaining safe and efficient operation of saw equipment. This role ensures timely preparation of materials to support production priorities and customer requirements. Other duties may be assigned as needed. Perform daily maintenance checks to ensure the saw is clean, operational, and in good working condition. Review and interpret rod drawings and related job documentation to ensure accurate cuts. Organize job paperwork based on priority, including premium, warranty, or standard orders, according to customer requirements and due dates. Retrieve required materials from stock shelves and prepare them for processing. Measure materials to the required lengths, adding a 1/8" allowance for machining where applicable. Operate abrasive and auto-feed saws to cut tubes and rods according to job priority. Match cut materials to rod drawings and verify accuracy before moving to storage or the next stage. Label cut stock with the appropriate job number and place in the designated location. To perform this job successfully, an individual must be able to perform each essential duty satisfactorily. The requirements listed above, and below, are representative of the knowledge, skill, and/or ability required. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions. Ability to read and interpret documents such as blueprints, orders, technical specifications, safety rules, operating and maintenance instructions, and procedure manuals. Ability to add, subtract, multiply, and divide in all units of measure, including whole numbers, common fractions, and decimals. Ability to compute rate, ratio, and percentage and to draw and interpret bar graphs. Ability to apply common sense understanding to carry out instructions furnished in written, oral, or diagram form. Ability to deal with problems involving several concrete variables in standardized situations. High school diploma or general education degree (GED); or two years related experience and/or training; or equivalent combination of education and experience. Able to operate abrasive cut saw and auto-feed saw. Proficiency in reading tape measures and using precision measuring instruments such as micrometers and calipers. Ability to read and interpret blueprints and technical drawings. Ability to operate a forklift and overhead crane (certification may be required). Knowledge of hydraulic and pneumatic cylinder components is a plus. Strong troubleshooting skills in a manufacturing environment. Strong attention to detail and commitment to quality. Strong safety awareness and use of proper PPE. Good teamwork and communication skills. The physical demands described here are representative of those that must be met by an employee to successfully perform the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions. While performing the duties of this job, the employee is regularly required to stand, use hands, reach with hands and arms, and talk or hear. The employee is frequently required to walk. The employee is occasionally required to sit and stoop, kneel, crouch or crawl. The employee must occasionally lift and/or move up to 25+ pounds. The work environment characteristics described here are representative of those an employee encounters while performing the essential functions of this job. Reasonable accommodation may be made to enable individuals with disabilities to perform the essential functions. While performing the duties of this job, the employee is required to wear safety glasses and hard sole/close toed shoes with a low heel when walking through the manufacturing shop and/or repair shop whether as part of performing their job or just passing through. In addition, long hair must be tied back when around hazards of flame, machinery, or equipment. While performing the duties of this job, the employee is regularly exposed to work near moving mechanical parts. The employee is frequently exposed to fumes or airborne particles and extreme heat (non-weather). The noise level in the work environment is usually loud.