Field Service Technician

Description PCT Ebeam and Integration in Davenport, IA is seeking 2 Field Service Technicians to provide support for testing, troubleshooting, repair and rebuild of electron beams. This position applies knowledge of mechanical and electrical processes such as high voltage, high vacuum, PLC controls, printed circuit board operation, hydraulic and pneumatic assembly. Travels on short notice for repair, calibration and installation of customer equipment in both domestic and international locations. Responsibilities Troubleshoots ebeam electron beam processors by identifying the malfunction’s root cause and determining the feasibility and scope of repair based on time and budget constraints. Troubleshoots both electrical and mechanical systems and components. Repairs or replaces defective parts, reassemble, calibrate, adjust and certify serviceability of overhauled or modified equipment. Tests and calibrates ebeam printed circuit boards using test equipment and written procedures and guidelines. Reads and understands both electrical and mechanical drawings. Responsible for familiarity and expertise on the design, assembly and operation of all ebeam product lines. When necessary assists in assembling, testing and installing ebeam components such as feed thru, cathode, copper window and high vacuum system and control system components. Assists in performing point-to-point wiring checks, and power up of new or rebuilt ebeam processor using test equipment and written procedures. Powers up, tests and commissions new ebeam systems on customer sites. Requirements Typically, an associate’s degree and 2 years' experience in a related field; or a high school diploma or equivalent and 4 years' experience in a related field. A minimum of 4 years' troubleshooting experience on electronic and mechanical equipment in an industrial and/or military environment. Ability to read, monitor and troubleshoot PLC programs - Siemens and Rockwell experience preferred. Knowledge of electrical, mechanical, industrial and safety standards (NEC, IEC, NEMA, NFPA, ISA, ANSI, OSHA). Ability to interpret drawings/prints and schematic diagrams and use these to troubleshoot and repair systems. Electron Beam or medical x-ray maintenance experience is a plus. Travel Project related travel to customer sites is required, including overseas travel. Ability to obtain current driver’s license and passport required. #J-18808-Ljbffr