Saw Operator

Reports To: Sample Department Supervisor Job Summary: This position is responsible for the following: Operate cutting equipment: Band saw, rotating knife saw and die press Cut material to standard sample size; adjust as required Maintain cut list schedule to sample inventory stock Pull roll stock per the schedule Load and Unload rolls as needed Maintain organization of roll stock and shelves Bagging cut samples properly following quality checks and requirements Stocking sample inventory Qualifications: Must haves for this position: Be able to read, write, and count correctly Basic Math, English, use a tape measure, weight scale, and micrometer Be able to follow both written and verbal work instruction Have good communication skills Be detail oriented Be able to change tasks, prioritize, and re-prioritize frequently and able to follow-up on work tasks as needed in a timely manner Be able to bend, twist, push, pull, and lift (Up to 50lbs; anything heavier than that should be a two-person lift) Wear proper Personal Protection Equipment (PPE) when applicable Must work in an uncontrolled temperature environment Operate a pallet jack Primary Duties: Cut material into samples to keep shelves stocked Responsible for communicating and assisting in the preventive and predictive maintenance of saw equipment Perform other job functions as directed by supervisor Quality check Assist Sample Clerk's when needed Quality: Adhere to material cut standards Review material after first cuts to inspect for quality of material Safety: Must commit to creating a culture where partners are protecting partners- "You See Something, Say Something!" Must comply with all company policies and procedures listed in the Leggett & Platt Employee Handbook Report all incidents, accidents, and near-misses to your supervisor immediately Assist in recognizing, responding, reporting, and eliminating hazards and assuring safety compliance Must participate in: On-the- Job (OJT) Training documentation Use of CAR/PARs (Corrective / Preventative Actions) Incident/Accident/Near-Miss Investigations to determine root cause Use of required PPE Participation in training events Good housekeeping in the work area and entire company grounds Must understand and commit to: No personal cell phone use on the production floor; Active cell phone use does not go beyond breaks and lunches No horseplay, yelling, or violence in the workplace No eating or open drinks are allowed on the production floor Environmental: Commit to environmental preservation through: Stormwater Pollution Prevention Participation in recycling initiatives Proper use of waste containers Participation in training events Requirements: You must be able to perform all job-related duties on or about: 90 days #J-18808-Ljbffr