Level II Ultrasonic Shear Wave Technician

SteelCon is Hiring – Level II UTSW Technician SteelCon is seeking an experienced and quality-driven Level II Ultrasonic Shear Wave (UTSW) Technician to support nondestructive testing and inspection of welded steel components. This position plays a critical role in ensuring weld quality, code compliance, and product integrity. We are looking for someone who takes ownership of their work, follows established procedures, communicates clearly with production and quality personnel, and understands that quality is never sacrificed for production. Key ResponsibilitiesPerform Ultrasonic Shear Wave Testing (UTSW) of welded steel components in accordance with applicable codes, specifications, written procedures, and customer requirements.Set up, calibrate, and operate ultrasonic testing equipment.Perform weld examinations and accurately identify, evaluate, and document relevant indications.Interpret UT results and determine acceptance or rejection in accordance with applicable acceptance criteria.Verify equipment calibration and maintain required inspection records.Prepare clear, complete, and accurate NDT inspection reports.Communicate inspection results and nonconforming conditions promptly to Quality and Production personnel.Maintain traceability of inspections and associated documentation.Follow SteelCon quality procedures, safety requirements, and established work instructions.Assist with investigation and verification of weld repairs when required.Work professionally with welders, supervisors, inspectors, and management to resolve quality issues without compromising inspection integrity.Maintain NDT equipment and ensure equipment is properly protected, stored, and ready for use.Required QualificationsCurrent Level II qualification/certification in Ultrasonic Testing (UT) with demonstrated shear-wave experience.Documented training and experience hours supporting Level II qualification.Experience performing ultrasonic shear-wave examination of structural steel welds.Ability to perform equipment calibration and system checks.Ability to interpret ultrasonic indications and evaluate weld discontinuities.Ability to read and understand fabrication drawings, weld symbols, inspection plans, specifications, and written NDT procedures.Strong understanding of weld discontinuities and welding-related defects.Ability to accurately complete inspection reports and maintain traceable quality records.Strong attention to detail and commitment to inspection integrity.Ability to communicate professionally with Production, Quality, and Management.Preferred QualificationsExperience performing UTSW inspection in a structural steel fabrication environment.Experience working to AWS D1.1 requirements.Familiarity with structural welding processes and common weld discontinuities.Experience with UT inspection of complete-joint-penetration (CJP) groove welds.Additional NDT certifications or experience, including MT or PT, are a plus.Previous experience working within an ISO 9001 or similar quality management system is beneficial.What We Expect At SteelCon, inspection is not simply about finding defects; it is part of building quality into the manufacturing process. The successful candidate will be expected to:Maintain independence and integrity when making inspection decisions.Follow approved procedures rather than relying on assumptions.Document results accurately and completely.Communicate problems early.Work with Production to identify and correct issues while maintaining required quality standards.Take ownership of assigned inspections from setup through final documentation.Maintain a professional and respectful approach when addressing nonconforming work.Never accept questionable work simply to maintain production schedules.Work Environment This position works primarily in a structural steel fabrication/manufacturing environment and may require standing, walking, climbing, bending, and accessing fabricated assemblies to perform inspections. The technician must be comfortable working around welding and fabrication operations while following all required PPE and safety procedures. Why SteelCon? SteelCon is committed to developing a culture built around quality, accountability, continuous improvement, professionalism, and ownership. We believe quality should be built into the process not inspected into the product after the fact. Our Level II UTSW Technician will be an important part of maintaining that standard and helping our fabrication teams continuously improve. Position: Level II UTSW Technician Department: Quality Employment Type: Full-Time Pay: $35 - $45hr based on experience Qualified candidates are encouraged to apply with a resume and documentation of applicable UT Level II training, certification, and experience.