Welding / Mechanical Inspector

Welding / Mechanical InspectorSGS is currently looking for a Welding/Mechanical Inspector for some contract work in Casper, Wyoming and San Diego, CA. This is not a full-time contract but some intermittent quality assurance work which will vary based on the projects. This project will start in June 2026.Scope of work:Responsible for inspecting, testing, and evaluating weld processes, welding, pressure vessels, heat exchangers, expansion joints, and related equipment to ensure compliance with applicable codes, safety standards, and regulatory requirements.Verify compliance with ASME, API, NBIC, Federal, state & Local regulations.Quality document reviews including WPS / PQR, assessment of quality, and issue reports or recommendations for corrective actions to ensure the safety and structural integrity of welded componentsInspecting welds, reviewing welding procedures, and conducting visual and dimensional inspectionsExamining completed welds for size, quality, and conformance to standards.Perform in-service inspections, turnaround inspections, and risk-based inspections (RBI).Conduct visual inspections of welded joints, checking dimensions, penetration, and bead formation.Witness non-destructive testing (NDT) and interpret / verify results.Visual inspection on the quality of welding and mechanical projects.Prepare detailed reports documenting inspection results, including any issues found.Observing welders and preheating proceduresRecording inspection results and any non-conformitiesInvestigating Non-Conformities i.e. identifying causes and assisting in corrective actions.Ability to communicate effectively with welders, engineers, and other personnelQualifications:At least one of the following: AWS CWI, API 510, API 570Minimum of five (5) years industrial welding-related inspection experience. Two (2) of these years should be in Quality Assurance / vendor surveillance / shop inspectionsIndustrial experience in Oil & gas / Power & Utility / Construction / Manufacturing, etc..Experienced in inspecting welds on various manufactured products eg. pipelines, expansion joints, pressure vessels, heat exchangers and other equipmentExperienced in witnessing NDE test (UT, PT, MT, RT, etc..) and verifying test reports.Work Schedule: Intermittent i.e. when & where required subject to job requirementPay Rate: $45 / hr. to $50 / hr.Per diems: Expenses will be covered at cost if inspection site is beyond round trip 200 miles from Inspector place of residence and requires overnight stay at hotel.SGS is an Equal Opportunity Employer, and as such we recruit, hire, train, and promote persons in all job classifications without regard to race, color, religion, sex, national origin, disability, age, marital status, sexual orientation, gender identity or expression, genetics, status as a protected veteran, or any other characteristics protected by law. To perform this job successfully, an individual must be able to perform each essential duty satisfactorily with or without reasonable accommodations. The requirements listed above are representative of the knowledge, skills, and/or abilities required. This job description should not be construed as an exhaustive statement of duties, responsibilities or requirements, but a general description of the job. Nothing contained herein restricts the company's rights to assign or reassign duties and responsibilities to this job at any time.