Machinist - 2nd Shift (Gear and Shaft)

Machinist - 2nd Shift (Gear and Shaft)

Eaton's AER FMC Fuel Motion Control Systems division is currently seeking a Machinist - 2nd Shift (Gear and Shaft) at our Euclid, Ohio plant! Core 2nd shift hours run from 3:30pm - 12am Monday - Friday. The hourly rate for this position is $29.86 plus $1/hr shift differential per hour. Please note the salary information shown above is a general guideline only. Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations.

What You'll Do:

The Fuel and Motion Control Systems Division of Eaton's Aerospace Group has an opening for a Certified Gear and Shaft Machinist. This position is based in Euclid, OH. The Euclid facility has approximately 300 employees and is a leader in the design, development, manufacture and delivery of Aerospace Fuel Pumping components, systems and services to the global aftermarket and OEM markets.

Job Summary: Set up and operate various drilling, milling, edge breaking, and burring machines to generate rough and finish dimensions on a variety of parts. Perform operations required to burr, polish, finish, and blend surfaces on machined parts. Perform visual and dimensional inspections and maintain accurate documentation on a variety of parts in accordance with ANSI Y14-5 and the certified operator program. Assistance may be given to other operators on proper operational procedures.

Job Responsibilities: Setup and operate super finish, lapping, center grinding equipment, balance, shot peen, edge breaking, sand vapor blast and burring machines to generate rough and finish dimensions on a variety of parts. Mount and accurately align various jig and fixtures, select speeds, and feeds. Load and align tooling, working from engineering layouts. Adjust stops and cams to produce finish dimensions to close tolerances. Utilize in-process gaging such as indicator arrangements, travel dials, etc., to ensure accurate size control. Read and interpret moderately complicated blueprints and execute quality checks using a variety of mechanical and electronic gages. Perform degrease and oiling operations on hardware. Setup and operate all equipment with minimum assistance, be familiar with work procedures involved with lapping, sub-assembly, balancing, super-finish, mill, drill and burring operations. Frequent changes in set-up and maintenance of close tolerance require constant attention. Maintain accurate lot control (QCP 6.0) traceability, record keeping, logbook entries, NCR's (QCP 11.0) and associated documentation. Final stocking operations for completed product as required. Maintain clean equipment and work area, Perform minor machine maintenance as needed. Chart and plot data per SPC requirement. Move material within the cell.

Qualifications:

Required Qualifications: High School Diploma or GED from an accredited institution. Must reside within a 50-mile radius of Euclid, Ohio; no relocation benefit is provided. Minimum two (2) years of machining (Non-CNC acceptable). Minimum 2-year GD&T Experience (successful completion of Eaton Level 1 Advanced Training will be considered in lieu of this requirement).

This position requires access to export-controlled information. To conform to U.S. Government export regulations applicable to that information, applicant must be a U.S. person, defined as a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (green card holder), (iii) refugee under 8 U.S.C. 1157, or (iv) asylee under 8 U.S.C. 1158.

Position Criteria:

Pass an Eaton vision test. Become a Certified Operator. Perform 5S and other duties as assigned. Complete Basics of Measurement courses