Hand Finisher -Deburr- Semiconductor Manufacturer

Hand Finisher

As a Hand Finisher, you will deburr, sand and clean parts on repeat or proven part(s) with simple to high complexity on a various materials such as aluminum, steel, plastic and copper with direction from area Lead or Supervisor.

Essential Duties

• Ability to communicate with production lead and supervisor
• Follow instructions
• Responsible for utilizing shop paper procedure including updates, signatures and stamps, counting quantities, labeling and non-conformance related activities
• Ensure an accurate router accompanies all work orders
• Ensure company procedures and "best machine practices" are being followed and are in place at all times
• Assist Lead person as needed
• Read blueprints, tooling instructions, and standard charts for specifications
• Follow blueprint or instructions to achieve required surface finishes such as lay patterns and sealing surfaces. Work independently to complete repeat tasks with little supervision.
• Operate a variety of pneumatic or electric power finishing tools such but not limited to orbital sander, DA sander, flappers and die grinders.
• Comply with applicable environmental, health and safety laws and regulations, Company policy and accepted safe work practices
• Perform additional related duties as assigned

Recommended Certificates, Licenses and Registrations

Completion of vocational education for machine technology or practical aspects of blueprint reading, GD&T preferred.

Education and/or Experience Required

High school diploma or general education degree (GED)

Previous finishing experience of 3-5 years preferred

Ability to read and comprehend basic instructions.

Ability to speak basic English language. Basic math and counting skills.

Knowledge of shop safety practices and use of PPE

Enrolled in vocational education for machine technology or practical aspects of blueprint reading, GD&T preferred. Basic knowledge of abrasive(s) progression required to achieve specific surface finishes.

Physical Demands While Performing the Job

Use of hands to handle, deburr, and finish parts

Frequently required to stand, walk, push, reach overhead, and bend to the floor

Frequently required to sit and use hands to finger, handle, or feel objects, tools, or controls

Occasionally lift and/or move up to 40 pounds

Specific vision abilities: close vision, depth perception, and adjust focus

Working Environment of the Job

High noise levels from operating machines

Physical hazards from moving equipment and machine parts