Mechanical Engineer III

Mechanical Engineer III (NS)

The North Carolina Department of Administration (DOA) is seeking applicants for a Mechanical Engineer for our State Construction Division. The State Construction Office (SCO) is responsible for the administration of planning, design and construction of all state facilities, including the university and community college systems. The division also provides the architectural and engineering services necessary to carry out the capital improvement program for all state institutions and agencies.

Key Responsibilities:

• Serve as the senior Mechanical Engineer for the Downtown Government Complex located in Raleigh. Provide engineering services for the DOA assigned buildings. Services include:
• Site investigation and analysis of building system problems.
• Recommendations for improvements and repairs.
• Preparation of plans, specifications and cost estimates for small renovation projects.
• Creation of reports as assigned by SCO Director or DOA Secretary.
• Position is required to work closely with DOA Facility Management staff to offer solutions and recommendations.
• Serve as a project manager for assigned DOA capital improvement (CI) projects. Work includes:
• Visit project sites on a weekly basis and attend project progress meetings.
• Monitor progress and inspect project to determine compliance with plans and specifications, conformance with completion schedule, adequacy of construction administration services by the designer, and resolution of construction problems.
• Provide review and approval of pay applications and Change Orders, including checking for adequate documentation and cost calculations per the construction contract General Conditions.
• Mitigate potential contract disputes.
• At the conclusion of a project, evaluate the project for completeness and conformance with contract documents and normal standards of workmanship and recommend project acceptance or denial.
• Upload all inspection results and meeting minutes into the State's reporting system.
• Provide plan review and approval, as the owner representative, for the design and construction documents related to the mechanical, plumbing and fire protection systems of capital improvement projects. This includes:
• Verify scope and estimated costs of projects with the contract requirements and the appropriate funds.
• Check submitted drawings and specifications for appropriate level of completion, accuracy and clarity in accordance with the standards for the complex.
• Review plans for appropriate energy efficient systems, energy conservation measures, serviceability and maintainability.
• Review plans for compliance with the NC General Statutes on public work, ensuring conformance of the contractual bid packages with State Construction Office guidelines, policies, and procedures.
• Review mechanical system aspects of projects submitted by designers to ensure compliance with the NC Building and safety codes, and conformance with sound engineering judgement and construction practices.
• Reviewing mechanical system designs for proper consideration to economy in initial and life cycle costs, maintenance cost, proper materials, and type of construction.
• Evaluate the mechanical system design with the architectural, civil, structural and electrical disciplines.
• Assist construction monitors working in the field in resolving technical or contractual issues at the construction site, as well as assisting in the overhead and final inspections.
• Provide Mechanical and Plumbing inspections on State owned buildings on an as needed basis. Requires obtaining a Level III certifications from the NC Code Qualifications Board. The State Construction Office is the Authority Having Jurisdiction (AHJ) for State owned facilities on State land or buildings.

Knowledge Skills and Abilities/Management Preferences

• Working knowledge of principles and practices of Building Systems Mechanical Engineering, NC State Building Codes and Industry Standards, General Construction policies and guidelines, building construction and operations.
• Discernment of discrepancies in technical documents or data and provide objective professional opinions and judgments when presented factual data.
• Familiar with industry design reference standards such as ASHRAE and NFPA and engineering development trends.
• Skilled in time management, communicating technical information to others, technical writing and written communication, constructive negotiations, and public speaking.
• Experience in Construction Administration and program/project management.
• Proficient with computer software and computer drawing packages.

Management Preference:

• Bachelor's degree in mechanical engineering.
• Minimum of 5 years progressive professional experience in the practice of Building Systems Mechanical engineering.
• Possession of a Level III North Carolina Inspector Certificate issued by the North Carolina Code Officials Qualification Board, or the ability to obtain within three (3) years of employment.

Necessary Requirements:

• Registration as a North Carolina Professional Engineer. Must provide proof of registration in application submittal.
• Minimum of 4 years progressively responsible experience in the practice of Building Systems Mechanical Engineering.
• Valid NC Driver's License with acceptable driving record. Out of State Applicants must have a valid NC Driver's License or acquire NC Driver's License within 60 days of hire. Candidate must present proof of a valid NC Driver's License and proof of an acceptable driving record.

Minimum Education and Experience

Some state job postings say you can qualify by an "equivalent combination of education and experience." If that language appears below, then you may qualify through EITHER years of education OR years of directly related experience, OR a combination of both. See the Education and Experience Equivalency Guide for details.

Bachelor's degree in an applicable field of engineering from an appropriately accredited institution and four (4) years of progressively responsible experience; or an equivalent combination of education and experience.

Necessary Requirement : Registration as a North Carolina Professional Engineer by the North Carolina Board of Examiners for Engineers and Surveyors.

Employment Incentives with NC State Government

We value our employees and offer a variety of competitive and family-friendly benefits including:

• 12 annual paid holidays
• Health Insurance and Supplemental Benefits including Dental and Vision.
• NC State Retirement Plan

Click more about employee perks and benefits at .
Contact NCDOA and follow us on social media at

SUPPLEMENTAL AND CONTACT INFORMATION:

The Department of Administration (DOA) is an Equal Opportunity Employer. DOA uses Merit-based Recruitment to select from among the most qualified applicants to fill positions subject to the State Human Resources Act.

Bonus qualified applicant must be selected from the candidate pool of this posting and meet the State policy following requirement :

"To be eligible for a Sign-on Bonus, the candidate must not have worked as a probationary, permanent, or time-limited employee in North Carolina State government, including the judicial system, or the University of NC system, within the last 12 months as an employee subject to the State Human Resources Act."

Eligibility and requirements will be discussed during the interview process.

This Sign-on Bonus is contingent upon budget and final eligibility determination as of the effective date of hire. Additional information regarding the Sign-on Policy can be found at .

** PLEASE SUBMIT YOUR APPLICATION ON-LINE USING THIS WEBSITE **

All applicants must complete and submit a state application for employment using the new Workday Online Job Application System for the State of North Carolina. To receive credit for your work history and credentials, you must list the information on the online application form. Any information omitted from the application cannot be considered for qualifying credit. Attached or incorporated resumes (including Text Resumes on application form) WILL NOT be used for screening for qualifying credit. Please make sure you complete the application in full. "See Resume" or "See Attachment" will NOT be accepted. Other attachments (except a DD-214 copy) will also be accepted but not used in screening for qualifying credit. Applicants are required to scan and attach a copy of their DD-214 (Form 4) or discharge orders if they wish to obtain veterans preference. Due to the volume of applications received, we are unable to provide information regarding the status of your application over the phone. To check the status of your application, please log in to your account and click "Application Status". It is not necessary to contact the