Sonic Inspector

We are currently seeking a Sonic Inspector in the Billet Inspection department at our Monroe, NC facility. As a sonic operator, you will play a valuable role in helping ensure our products and materials meet customer expectations. As a sonic operator, you will be responsible for processing material in the sonic tank and through the immersion tactic to perform contact sonic. A successful candidate should demonstrate an eagerness to learn, showing initiative, commitment to teamwork, attention to detail, integrity, and honesty. This is a night shift position from 6:00 pm to 6:00 am, working on a rotating 2-2-3 schedule. You will work 2 days, have 2 days off, work 3 days; then 2 days off, work 2 days, then have 3 days off. Additional Responsibilities Perform tasks to assist in set‑up and operating equipment Follow prescribed safety regulations Maintain accurate, complete, and legible logs, records, and charts Operate heavy machinery such as forklifts and cranes Train for 3 months (or 400 hours) and receive 40 hours of classroom training and hands‑on instruction Learn to operate all instruments and test systems Learn to read technical instructions and mill instructions Written and practical examinations will be administered after 3 months training Upon receiving passing results, will reach level I after completing 400 hours of training Level I Continue training in the above tasks Must be able to make specific calibrations of all test systems according to procedures Must be able to verify that equipment is calibrated Will be able to operate the equipment under the direct supervision of a Level II Will receive 40 hours of classroom training to perform all techniques necessary to become a Level II inspector including immersion testing (nuclear and non‑nuclear) and contact testing (nuclear and non‑nuclear) After 12 months (or 1600 hours), no more than 14 months experience since the beginning of training, and 40 hours of classroom training, a written practical examination will be administered Failure to pass the examination on the third attempt will disqualify that person to be Level II and will require assignment to another job if available and qualified Level II Will be able to operate all equipment and systems, in all techniques (immersion, contact, longitudinal, shear wave, nuclear and non‑nuclear). Will be able to accept or reject indications, perform calibrations, and work to all procedures as required Should be able to organize and report inspection results in a thorough manner Must be thoroughly familiar with the scope and limitations of the techniques for which the individual is qualified and must be able to apply those techniques as required Requalification will be every 3 years by written and practical examination as required by T.I. QC-20 addenda 1 and 2 Failure to requalify on 3rd attempt will result in the same actions as above. An employee must work in the position for a minimum of 2 years to be eligible for job posting. It is ATI's policy to not provide immigration sponsorship for any of the company's positions. Requirements Preferred Qualifications One (1) year of manufacturing experience is preferred Skills Basic math skills, including addition, subtraction, multiplication, and division in all units of measure including whole numbers, fractions, and decimals Basic computer skills Ability to read tape measure and micrometer Ability to read and understand instructions Ability to utilize common hand tools Ability to lift objects weighing up to fifty (50) pounds and work in hot conditions Required to pass in‑dept vision screening Pass Sonic Assessment Status Full‑time Work Arrangement Onsite Equal Employment Opportunity Statement This Company is an Equal Opportunity Employer, and does not discriminate on the basis of race, gender, ethnicity, religion, national origin, age, disability, veteran status, or on any other basis prohibited by law. Information on race, gender and national origin will only be used for statistical and record‑keeping purposes and will not be used in making any employment decisions. All information provided will be kept separate from your expression of interest. Providing this information is strictly voluntary, and you will not be subjected to any adverse action or treatment if you choose not to provide this information. If you do not choose to answer these questions, we ask that you select “Decline to Identify” for each question. Thank you for your voluntary cooperation. #J-18808-Ljbffr RadNet, Inc.