Laminated Builder

Job Description

Job Description

Laminated Builder I

Location:  Arlington, TX

SHIFT:  Aerospace – Day Shift M-Th 5:30am-4pm and Fri 6:30am-2:00pm.  Some Saturdays 5:30-noon  - This position will use grinders, knives and scissors all day removing flashing and buffing off rubber.  It’s a hot and dirty environment

Pay:  $16.00

POSITION SUMMARY:

Under close supervision, builds parts efficiently according to specific build-up requirements. 

ESSENTIAL DUTIES AND RESPONSIBILITIES:

• Sets-up and prepares parts for build-up. 

• Organizes materials and tools required for build-up. 

• Checks setup lights. 

• Weighs, measures and cuts materials for lamination. 

• Checks mandrel dimensions.

• Trims and buffs parts.

• Builds parts by following prescribed procedures using an MIP. 

• Builds/assembles a part, molds the part and disassembles the part. 

• Repairs parts as necessary. 

• Reads and records measurements in the MIP. Stamps the MIP as required. 

• Maintains a clean and safe work area. 

• Follows safe work practices and instructions, and exercises stop work authority if needed. 

• Perform other duties as assigned by supervisor. 

QUALIFICATION REQUIREMENTS:

• Entry level position. 

• Common knowledge of manufacturing environment preferred. 

• Understand and follow written and verbal instructions in English. 

• Good verbal and written communication skills in English. 

• Build parts while maintaining acceptable production and quality standards. 

• Basic mathematical skills (addition/subtraction, multiplication/division).

• Willingness to learn. • Attention to detail is required. 

TOOLS AND EQUIPMENT USED (Not All Inclusive):

• Stamp for MIP • Paint brush (for chemicals and paint) 

• Rolling hand tools to shape or flatten rubber (stitchers, perforators, etc.) 

• Xacto knife, blade, scissors (to cut fabric and rubber) 

• Trimmers (hand held manual) 

• Buffer (hand held electric) 

• Clicker machine (cuts rubber with cutting board) 

• Screw driver, rachet, socket, wrench, allen wrench, plyers 

• Syringe with needle to remove air pockets from rubber 

• Ruler, tape measure 

• Impact (electric) 

• Clamps 

• Caliper 

• Dolly/Cart 

• Electric drill 

• Air hose 

• Crane

Send us your resume!!

#DFWA