Production Electrician-First Shift

Electrician
Industrial Electrician – Hands-on experience in electrical installation, conduit bending, wire pulling, and low-voltage controls. This position will install and wire electrical components while working from blueprints and electrical layouts. Candidates should have knowledge of Lockout/Tagout (LOTO) procedures, basic NEC codes, and experience using electrical hand and power tools in an industrial or manufacturing environment.
Pay rate & Scheduled:

• $23.00 Hourly
• 1st Shift: Monday – Friday: 8:00AM – 5:00PM

Install and wire electrical components on manufacturing units and equipment
Assist with electrical layouts according to blueprints and engineered drawings
Install various electrical components and devices
Install low-voltage control devices
Bend and install conduit using hand benders
Pull and route electrical wiring
Take accurate measurements using a tape measure
Follow proper Lockout/Tagout (LOTO) procedures
Use hand and power tools, including:
Conduit hand benders
Pipe threaders
Cordless drills
Saws
Impact wrenches
Rivet/pop guns
Vice grips, tongs, and snips
Various air and electric-powered tools

Follow all established electrical and workplace safety procedures
Maintain a clean and organized work area
Perform additional electrical and production duties as needed
Previous industrial electrical experience required
Experience with conduit bending and wire pulling
Knowledge of Lockout/Tagout (LOTO) procedures
Familiarity with basic NEC electrical codes
Ability to read and understand electrical blueprints and drawings
Ability to accurately read and use a tape measure
Must be mechanically inclined
Experience using electrical hand and power tools
Comfortable climbing ladders and using fall-protection equipment
Ability to lift, push, pull, and move up to 50 lbs.
Ability to stand, walk, reach, bend, and perform physical work throughout the shift
Strong attention to detail and commitment to workplace safety