Quality Control Inspector

Quality Assurance Inspector

100% onsite at New Port Richey FL Shift Mon-Fri - 8:00am-4:30pm

Top 3 "must-have" skills or qualities in a candidate:

• Able to use calipers, micrometers, height gages, comparator oscilloscopes, and other measuring devices
• Experience in AS9100, ISO9001
• Willingness to work overtime

Essential Job Functions:

• Perform first piece, receiving inspection, in process inspections, and source inspections as required.
• Operate CMM (coordinated measuring machines), using calipers, micrometers, height gages, comparator oscilloscopes and other devices to inspect purchased and manufactured parts, subassemblies, final assemblies and first article inspections, as required.
• Document inspection findings as needed in corrective action reports.
• Complete First Article Inspections (FAIRs) Create FAIRs reports.
• Work under the direction of supervisors or more experienced personnel with little supervision.
• Communicate ideas, problems, and concerns to management.
• Perform Kamishibai daily.
• Understand and follow verbal and written instructions.
• Complete all necessary paperwork as required including scorecards, hazard recognitions, routers and data.
• Perform other tasks as assigned.
• Work overtime as required.

Minimum Qualifications:

• Must have a high school diploma or equivalent (i.e. GED).
• Minimum of five (5) years of quality assurance inspection experience within a manufacturing high mix and complex product environment.
• Working knowledge and experience in AS9100, ISO9001, Repair Station, FAA (Federal Aviation Administration) regulations, PRMRB (Preliminary Review and Material Review Boards) and QMS (Quality Management Systems) processes.
• Demonstrated ability to perform multiple tasks in a fast-paced manufacturing environment with high mix and complex products.
• Familiar with Discus First Article software and Net Inspect.
• Knowledge and experience using SAP or other ERP systems.
• Experience using Mauser/Zeiss/Mitutoyo/Brown and Sharp CMMs.
• Knowledgeable and experienced in interpreting complex electrical and mechanical engineering part drawings and GD&T (Geometric tolerancing).
• Highly skilled with calipers, micrometers, micro-hite, comparators, height gages, verniers, and surface finish measuring instruments, comparator oscilloscopes, and other precision instruments.
• Experience with First Piece Inspection, Final Inspection, Receiving inspection and Source inspection.
• Computer literacy in MS Office (i.e. Excel, Word, Outlook, Data Entry).
• Able to travel (domestically) to visit the customer as well as for training (10%).
• Ability to write CAPAs
• Ability to create DIR/DIPs using correct AQLs based of customer flow down requirements.
• Work overtime and flexible hours as required.

Physical Requirements:

• Bending, lifting, sitting, standing and twisting for long periods of time.
• Successfully pass the Ishihara's Test for Color Deficiency, and Jaeger Level 1 examinations.
• Must have a minimum of a 20/25 vision (with correction).
• Required to lift a minimum of 30 pounds. Lifting frequency: Daily.
• Good eye and hand dexterity.
• Frequent standing or sitting for extended periods
• Bend, lift, sit, twist and/or stand for long periods of time
• Must be able to work with solvents, oils, and other chemicals as required