Manufacturing Technician

Manufacturing Tech CElectronics Test TechnicianWe are seeking a skilled technician to perform depot-level, component-level testing of military avionics displays and control units for platforms including C-130J, F-35, Apache, and Blackhawk. This hands-on bench position requires the ability to troubleshoot circuit card assemblies down to individual components using schematics, test equipment, and diagnostic procedures. You will use oscilloscopes, freeze spray, and multimeters to identify and replace defective resistors, capacitors, ICs, and other components on complex multi-layer PCBs. This is NOT an IT or computer support role - we need technicians with electronics repair experience who are comfortable with reading circuit diagrams.Key Responsibility Statements:Perform component-level diagnosis of CCAs (Circuit Card Assemblies) using schematics, test procedures, and diagnostic equipmentUse oscilloscopes, multimeters, function generators, and spectrum analyzers to isolate faults to specific componentsRead and interpret electronic schematics, wiring diagrams, and technical manualsPerform continuity checks, voltage measurements, and signal tracing on populated circuit boardsIdentify defective resistors, capacitors, diodes, transistors, ICs, and connectorsDocument repairs using depot-level maintenance proceduresWork at an electronics repair bench with ESD controlsRequired Skills Section:Ability to read electronic schematics and circuit diagramsExperience with bench test equipment: oscilloscopes, DMMs, power supplies, signal generatorsComponent identification and replacement skillsUnderstanding of analog and digital circuit theoryExperience with printed circuit board repairPreferred:Military avionics maintenance background (2M, AT, AE, 94F MOS)Experience with military displays (AMLCD, CRT, LED)Security clearance (active or ability to obtain)Equipment/Environment Description:You will work at an electronics repair bench in a temperature-controlled environment using:Hot air rework equipmentStereo microscopesOscilloscopes and logic analyzersIn-circuit testersX-ray inspection equipmentESD-safe workstationsEducation/Background:• Electronics Technology degree or certificate from technical school, OR • Military electronics training (avionics, radar, communications), OR • Equivalent hands-on experience in electronics repair/manufacturing Education & ExperienceRequires fully proficient job knowledge/skills. Requires a High School Diploma or equivalent and a minimum of 6 years of prior relevant experience or 2 years post-Secondary/Associates Degree with a minimum of 2 years of prior related experience.