Senior Cable and Wire Harness Assembler

$25 to $30 per hour | First shift, 7:00 AM to 3:30 PM, Monday to Friday | Plymouth, MN Ready to be the hands everyone else measures up to? Source Engineering & Manufacturing is looking for a Senior Cable and Wire Harness Assembler to join our Plymouth, MN manufacturing site. This is a senior individual-contributor seat: you'll take on our most complex builds, run first articles, and set the workmanship standard newer assemblers learn by watching you work. Your Role Will Include: Build our most complex cable and wire harness assemblies from drawings, schematics, and work instructions with minimal supervision. Perform precision wire cutting, stripping, crimping, soldering, potting, labeling, and bundling to IPC/WHMA-A-620 standards. Run and document first-article builds, helping dial in fixturing and tooling before a job moves to volume. Read complex engineering drawings and flag errors or ambiguities back to engineering. Inspect your own and others' work for quality and compliance. Qualifications: 5+ years of hands‑on cable and wire harness assembly experience. Demonstrated mastery of crimping, soldering, and connector termination across multiple connector families. Ability to work independently from complex engineering drawings, wire lists, and schematics. Proven first-time‑right workmanship and low defect rates. Strong attention to detail and disciplined, repeatable technique. Experience building complete cable assemblies end‑to‑end, not single‑station/high‑volume work. IPC/WHMA-A-620 workmanship standards experience, even without formal certification. Preferred Current IPC/WHMA-A-620 certification (CIS); training and certification provided if not already certified. IPC/WHMA-A-620 CIT (Certified IPC Trainer). J-STD-001 soldering certification. Control panel build experience. Salary and Benefits: $25–$30 per hour, based on experience and certification level. 401(k), health and dental insurance, and performance bonuses. Location & Shift Times: Plymouth, MN (on‑site). First shift, 7:00 AM–3:30 PM, Monday–Friday; FT. Physical Demands: Fine motor control, close vision, and sustained focus at a bench. Frequent repetitive hand/wrist movement; extended periods seated or standing. Occasional lifting and moving of parts up to 35 lbs. #J-18808-Ljbffr DP Gayatri