QC Fabrication Inprocess Inspector

The QC Fabrication In-process Inspector position reports directly to the QC Fabrication Inspection Supervisor and performs the following in-process inspections in the fabrication department. Laser Cut and Formed Metal In-process Inspection Responsibilities Verifies cut components are free of burrs and sharp edges Verifies bent components are bent in the proper orientation by comparing the component to the engineered drawings. Signs off on in process inspection checklists validating successful inspections. Copper Forming and Epoxy Insulation In-Process Inspection Responsibilities Verifies all copper hole punching is free from burrs or damaged to copper components. Verifies epoxy insulation is free from knicks, burns, cuts or visible damage Confirms copper length to engineered drawings. Welding In-Process Inspection Responsibilities Verifies proper fit-up/alignment of laser cut/formed components prior to welding Verifies welds on components prior to completed assembly welds Confirms components are properly identified with part number labels/engravings Component Powder Coating In-Process Inspection Responsibilities Verifies paint finish does not contain any peeling, bubbling or discoloration using paint color chip(s) Verifies correct paint mil thickness The in-process Inspector will Be responsible for utilizing squares and mil thickness gauges to validate component compliance. Form fills paperwork to validate inspections completed Complete NCRs to ensure nonconforming products are properly addressed and documented. Requirements High school diploma or GED required 1–3 years of manufacturing, fabrication, QC, or inspection experience required Ability to read engineered drawings and verify part compliance Ability to use inspection tools such as squares, rulers, and mil thickness gauges Ability to identify fabrication, welding, insulation, and coating defects Strong documentation skills, including inspection forms and NCRs Strong attention to detail and commitment to quality and safety Preferred 3+ years of in-process inspection experience in a fabrication environment Experience with sheet metal, copper forming, welding, epoxy insulation, or powder coating inspection Experience with NCR documentation and quality systems Familiarity with additional measurement tools such as calipers and micrometers Experience in switchgear, electrical manufacturing, or custom industrial fabrication Bilingual English/Spanish preferred #J-18808-Ljbffr Spike Electric